We present a parametric driving method to cool an ultracold Fermi gas in a crossed-beam optical dipole trap. This method selectively removes high-energy atoms from the trap by periodically modulating the trap depth with frequencies that are resonant with the anharmonic components of the trapping potential.
We present a cooling method for a cold Fermi gas by parametrically driving atomic motions in a crossed-beam optical dipole trap (ODT). Our method employs the anharmonicity of the ODT, in which the hotter atoms at the edge of the trap feel the anharmonic components of the trapping potential, while the colder atoms in the center of the trap feel the harmonic one. By modulating the trap depth with frequencies that are resonant with the anharmonic components, we selectively excite the hotter atoms out of the trap while keeping the colder atoms in the trap, generating parametric cooling. This experimental protocol starts with a magneto-optical trap (MOT) that is loaded by a Zeeman slower. The precooled atoms in the MOT are then transferred to an ODT, and a bias magnetic field is applied to create an interacting Fermi gas. We then lower the trapping potential to prepare a cold Fermi gas near the degenerate temperature. After that, we sweep the magnetic field to the noninteracting regime of the Fermi gas, in which the parametric cooling can be manifested by modulating the intensity of the optical trapping beams. We find that the parametric cooling effect strongly depends on the modulation frequencies and amplitudes. With the optimized frequency and amplitude, we measure the dependence of the cloud energy on the modulation time. We observe that the cloud energy is changed in an anisotropic way, where the energy of the axial direction is significantly reduced by parametric driving. The cooling effect is limited to the axial direction because the dominant anharmonicity of the crossed-beam ODT is along the axial direction. Finally, we propose to extend this protocol for the trapping potentials of large anharmonicity in all directions, which provides a promising scheme for cooling quantum gases using external driving.
В последние два десятилетия, различные методы охлаждения были разработаны для генерации Бозе-Эйнштейна конденсаты (БЭК) и вырожденного Ферми – газа (ДФГ) от горячих атомных паров 1, 2, 3, 4, 5. БЭК и ДФГ являются новыми фазами вещества, которые существуют в крайне низких температурах, как правило, одной миллионной градуса выше абсолютного нуля температуры, значительно ниже тех, которые обычно найдены на Земле или в космосе. Для того, чтобы получить такие низкие температуры, большинство методов охлаждения полагаются на понижение удерживающего потенциала к испарительным охладить атомы. Тем не менее, снижение схема также снижает скорость столкновения атомов, что ограничивает эффективность охлаждения , когда газ достигает квантовый режим 6. В этой статье мы представляем «высылающий» метод испарительного охлаждения газа в ультрахолодных Ферми в ODT безпонижая глубину ловушки. Этот метод основан на нашем недавнем исследовании параметрического охлаждения 7, показывающий ряд преимуществ по сравнению с понижающих схемами 7, 8, 9.
Основная идея параметрической схемы является использование ангармоничности ODT пересекли пучок, что делает более горячие атомы вблизи края потенциала захвата чувствовать низкие частоты отлова, чем холодные атомов в центре. Это энгармонизм позволяет более горячие атомам быть селективно исключены из ловушки при модуляции удерживающего потенциала на частотах резонансных с атомами высоких энергий.
Экспериментальный протокол параметрического охлаждения требует предварительного охлаждения газа невзаимодействующих Ферми вблизи температуры вырожденной. Для реализации данного протокола, акустооптический модулятор (АОМ) используется для модуляции интенсивности захвата пучков по controllinг частотная модуляция, глубина и время. Для того, чтобы проверить, охлаждающий эффект, атомное облако зондирования поглощения изображений времени пролета (TOF), где резонансный лазерный луч освещает атомное облако и тень поглощения захватывается прибором с зарядовой связью (ПЗС) камерой. Свойства облака, такие как число атомов, энергия и температуры, определяются плотностью столбца. Для того, чтобы охарактеризовать охлаждающий эффект, мы измерить зависимость энергий облака на различные моменты времени модуляции.
Мы представляем экспериментальный протокол для параметрического охлаждения невзаимодействующого Ферми газа в оптической ловушке пересекла пучок. Критические шаги этого протокола включают в себя: Во-первых, оптически ловушке Ферми газ должен быть охлажден близко к вырожденной темпе…
The authors have nothing to disclose.
We thank Ji Liu and Wen Xu for involving in the experimental setup. Le Luo is a member of the Indiana University Center for Spacetime Symmetries (IUCSS). This work was supported by IUPUI and IUCRG.
500 mW 671 nm ECDL | Toptica | TA Pro | Quantity:1 |
35 mW 671 nm ECDL | Toptica | DL-100 | Quantity:1 |
671 nm AOM | Isomet | 1206C | Quantity:3 |
671 nm AOM Driver | Isomet | 630C-110 | Quantity:3 |
100 W 1064 nm CW laser | IPG photonics | YLR-100-1064-LP | Quantity:1 |
1064 nm AOM | IntraAction | ATM-804DA6B | Quantity:1 |
1064 nm AOM Driver | IntraAction | ME-805EH | Quantity:1 |
Arbitrary Function Generator | Agilent | 33120A | Quantity:3 |
Digital I/O Board | United Electronic Industries | PD2-DIO-128 | Quantity:1 |
System Design Platform | National Instruments | LabVIEW | Quantity:1 |
Analog Voltage Output Device | Measurement Computing | USB-3104 | Quantity:1 |
CCD Camera | Hamamatsu | Orca R2 | Quantity:1 |
Arbitrary Pulse Generator | Quantum Composer | 9618+ | Quantity:1 |
Analog Voltage Output Device | Measurement Computing | USB-3104 | Quantity:1 |
20 A power supply | Quantity:1 | ||
10 A power supply | Quantity:1 | ||
120 A power supply | Quantity:2 | ||
Cooling Fans | Quantity: depends on apparatus design | ||
671 nm Mirrors | Quantity: depends on apparatus design | ||
671 nm Half-wave Plate | Quantity: depends on apparatus design | ||
671 nm Quarter-wave Plate | Quantity: depends on apparatus design | ||
500 mW Beam Shutter | Quantity: depends on apparatus design | ||
671 nm Lenses | Quantity: depends on apparatus design | ||
Faraday Isolator | Quantity: 2, one for each ECDL | ||
671 nm Polarizing Beam Splitter | Quantity: depends on apparatus design | ||
Photodetector | Thorlabs | SM05PD1A | Quantity:1 |
Multiplexer | Analog Devices | ADG409 | Quantity: 1 |
Multiplexer | Analog Devices | ADG408 | Quantity: 2 |
1064 nm plano-concave lens | Quantity:1 for beam reducer | ||
1064 nm plano-convex lens | Quantity:1 for beam reducer | ||
1064 nm Mirrors | Quantity: depends on apparatus design | ||
1064 nm Half-wave Plates | Quantity: depends on apparatus design | ||
1064 nm Lenses | Quantity: depends on apparatus design | ||
1064 nm Thin Film Polarizer | Quantity:1 | ||
100 W, 1064 nm Beam Dump | Quantity:1 | ||
100 W, 1064 nm Power Meter | Quantity:1 | ||
RF Function Generator | Rigol | DG4162 | Quantity:1 |
RF Power Amplifier | Mini-Circuits | ZHL-100W-GAN+ | Quantity:1 |