In Vitro Measurement of α-Galactosidase A and Acid α-Glucosidase Enzyme Activity

Published: February 29, 2024

Abstract

Source: Lukas, J., et al. In Vitro Enzyme Measurement to Test Pharmacological Chaperone Responsiveness in Fabry and Pompe Disease. J. Vis. Exp. (2017)

This video demonstrates the in vitro measurement of enzyme activity for α-galactosidase A and acid α-glucosidase in samples using synthetic 4-Methylumbelliferyl substrates.

Protocol

1. Cell Harvest and α-galactosidase A or Acid α-glucosidase Activity Measurement

  1. Cell harvest
    1. On the day of the harvest, remove the cells from the incubator and aspirate the medium. Carefully wash the cells 2 times with PBS with Ca2+ and Mg2+.
      NOTE: This step is critical because DGJ and DNJ are potent inhibitors of α-galactosidase and α-glucosidase, respectively, and any leftover would invalidate the test.
    2. Add 200 µL of deionized water directly on top of the cells. Rinse the cells from the plate and transfer them to a 1.5 mL reaction tube.

2. Homogenization by freezing and thawing

  1. Put the samples in an appropriate foam rack and vortex for 5 s to make the lysis more efficient. Put the samples alternating in liquid nitrogen for 10 s and in a room-temperature water bath until the thawing was complete (5 min).
  2. Repeat this procedure 5 times and then spin the samples for 5 min at 10,000 x g. Retain the supernatant and pipette in a new reaction tube.

3. Protein concentration determination using bicinchoninic acid (BCA) assay

  1. Prepare a fresh tube for each sample containing 40 µL of deionized H2O and add 10 µL of the sample. Mix solution by vortexing briefly and transfer 10 µL into a cavity of a 96 well plate (each sample in triplicate). Dilute a 2 mg/mL bovine serum albumin (BSA) stock solution in deionized H2O as follows to obtain a standard curve: 50 µL H2O/50 µL BSA; 60 µL H2O/40 µL BSA; 70 µL H2O/30 µL BSA; 80 µL H2O/20 µL BSA; 90 µL H2O/10 µL BSA; 100 µL H2O.
  2. Start the reaction by adding 200 µL of BCA reagent (Reagent A and reagent B mixed at a 50:1 ratio) and incubate for 1 h in the dark at 37 °C under slight agitation on an orbital shaker (300 rpm). Measure the absorbance at 560 nm in a plate reader.
    NOTE: The samples typically contain between 1 and 1.5 µg protein per µL.

4. Enzyme activity measurement with artificial 4-Methylumbelliferyl substrates (4-MUG)

  1. Dilute the calculated amount of each sample and pipet into fresh 1.5 mL reaction tubes to obtain 0.05 (for α-galactosidase A) or 0.5 (for acid α-glucosidase) µg protein/µL solutions. Vortex the samples for 5 s again and pipet 10 µL of this dilution into a 96-well plate (each sample in duplicate).
  2. Start the reaction by adding 20 µL of the respective substrate solution:
    For α-galactosidase A: 2 mM 4-Methylumbelliferyl-α-D-galactopyranoside (4-MU-gal) in 0.06 M phosphate citrate buffer, pH 4.7.
    For acid α-glucosidase: 2 mM 4-methylumbelliferyl α-D-glucopyranoside (4-MU-glu) in 0.025 M sodium acetate, pH 4.0.
  3. Incubate the enzyme reactions for 1 h in the dark at 37 °C under slight agitation on an orbital shaker (300 rpm). Terminate the reaction by the addition of 200 µL of 1.0 M, pH 10.5 adjusted glycine-NaOH buffer.
  4. Prepare a standard curve of 4-methylumbelliferone (4-MU) from a 0.01 mg/mL stock as follows:
    100 µL H2O/ no 4-MU; 80 µL H2O/ 20 µL 4-MU; 60 µL H2O/ 40 µL 4-MU; 40 µL H2O/ 60 µL 4-MU; 20 µL H2O/ 80 µL 4-MU; no H2O/ 100 µL 4-MU, pipet 10 µL of each dilution into the 96 well plate (in duplicates) and add 200 µL of the 1.0 M glycine-NaOH buffer to each well in order to adjust the volume and pH.
  5. Measure the enzyme activity in a fluorescence reader equipped with the appropriate filter set and analyze the data using the appropriate software for the fluorescence reader device.
    NOTE: Both 4-MUG substrates are reduced to 4-MU during exposure to α-galactosidase A or acid α-glucosidase. Released 4-MU is a fluorochrome, which can be measured at 360 and 465 nm as the excitation and emission wavelengths, respectively, using a microplate fluorescence reader.

Declarações

The authors have nothing to disclose.

Materials

Sodium chloride Merck, Darmstadt, Germany 1,06,40,41,000
Potasium chloride Merck, Darmstadt, Germany 1,04,93,60,500
MgCl2 x 6H2O Merck, Darmstadt, Germany 1,05,83,30,250
D (+)-Glucose monohydrate Merck, Darmstadt, Germany 1,08,34,22,500
Sodium Hydroxide Merck, Darmstadt, Germany 1,06,49,80,500
Sodium acetate Merck, Darmstadt, Germany 1,06,26,40,050
HEK293H cell line Invitrogen, Karlsruhe, Germany 11631-017
SafeSeal reaction tubes, 1.5mL Sarstedt, Nümbrecht, Germany 72,706
Tecan GENios Reader Tecan, Männedorf, Switzerland
Magellan data analysis software v6.6 Tecan, Männedorf, Switzerland N.A

Tags

Play Video

Citar este artigo
In Vitro Measurement of α-Galactosidase A and Acid α-Glucosidase Enzyme Activity. J. Vis. Exp. (Pending Publication), e21997, doi: (2024).

View Video