In Vivo Biomechanical Testing of Nerve: A Procedure for Biomechanical Analysis of Brachial Plexus Nerve Injury in a Neonatal Pig Model
Trascrizione
To set up the biomechanical testing device, attach the base of the device to a cart, and use large C-clamps to attach the electromechanical actuator to the base. Attach a 200-Newton load cell to the actuator, and screw in a clamp with padded plexiglass, to prevent stress concentration at the clamping site.
Using a tripod, attach a camera that can record up to 100 frames per second at a 658 x 492 pixel resolution, and attach USB cables from the camera, actuator, and load cell to the computer, to integrate and synchronize all of the components of the setup. Then, plug the computer, actuator, and load cell into a power source.
To calibrate the load cell before recording the applied loads, use the adjustable handle to set the actuator at a 90-degree angle, such that it is aligned vertically, and check the angle with a protractor. Open the load cell software and click Start to show a live readout of the voltage.
Next, hang 0 to 1,000-gram weights from the clamp at 100-gram increments, recording the measured voltages at each load. When the voltages have been recorded for all 10 weights, calculate the slope, and intercept, to determine the linear equation of the voltages and weights.
For biomechanical testing of the isolated brachial plexus nerve, use fine scissors to cut the nerve, and use a custom clamp to clamp the cut side of the nerve. Label the clamped nerve segment with black acrylic paint, and place a 1-centimeter ruler flat within the animal to set the scale for the data analysis. In the camera software, place the camera field of view directly over the tested segments to allow monitoring of the motion and/or displacement of the markers, and to determine the actual tissue strain at a specific time point.
Record the baseline measurements, such as the height at which the nerve inserts into the body from the table, the height of the clamp from the table, the angle of the actuator, and the full length of the tissue. Open the programming software and click Run. Enter the file name and displacement and click Initialize and TARE. Click Start to stretch the brachial plexus segment.
The tissue will be pulled at an assigned rate of 500 millimeters per minute until complete failure occurs in any segment of the nerve tissue. Then, save a video file, the applied tensile load, the displacement of the tissue, and the duration of the test, and record the failure site as the segment at which the tissue ruptures.
