Summary

DNA Extraction from Paraffin Embedded Material for Genetic and Epigenetic Analyses

Published: March 26, 2011
doi:

Summary

This video demonstrates the protocol for DNA extraction from formalin-fixed paraffin-embedded material. This is a multi-day procedure in which tissue sections are deparaffinized with xylene, rehydrated with ethanol and treated with proteinase K to purify and isolate DNA for subsequent gene-specific or genome-wide analysis.

Abstract

Disease development and progression are characterized by frequent genetic and epigenetic aberrations including chromosomal rearrangements, copy number gains and losses and DNA methylation. Advances in high-throughput, genome-wide profiling technologies, such as microarrays, have significantly improved our ability to identify and detect these specific alterations. However as technology continues to improve, a limiting factor remains sample quality and availability. Furthermore, follow-up clinical information and disease outcome are often collected years after the initial specimen collection. Specimens, typically formalin-fixed and paraffin embedded (FFPE), are stored in hospital archives for years to decades. DNA can be efficiently and effectively recovered from paraffin-embedded specimens if the appropriate method of extraction is applied. High quality DNA extracted from properly preserved and stored specimens can support quantitative assays for comparisons of normal and diseased tissues and generation of genetic and epigenetic signatures 1. To extract DNA from paraffin-embedded samples, tissue cores or microdissected tissue are subjected to xylene treatment, which dissolves the paraffin from the tissue, and then rehydrated using a series of ethanol washes. Proteins and harmful enzymes such as nucleases are subsequently digested by proteinase K. The addition of lysis buffer, which contains denaturing agents such as sodium dodecyl sulfate (SDS), facilitates digestion 2. Nucleic acids are purified from the tissue lysate using buffer-saturated phenol and high speed centrifugation which generates a biphasic solution. DNA and RNA remain in the upper aqueous phase, while proteins, lipids and polysaccharides are sequestered in the inter- and organic-phases respectively. Retention of the aqueous phase and repeated phenol extractions generates a clean sample. Following phenol extractions, RNase A is added to eliminate contaminating RNA. Additional phenol extractions following incubation with RNase A are used to remove any remaining enzyme. The addition of sodium acetate and isopropanol precipitates DNA, and high speed centrifugation is used to pellet the DNA and facilitate isopropanol removal. Excess salts carried over from precipitation can interfere with subsequent enzymatic assays, but can be removed from the DNA by washing with 70% ethanol, followed by centrifugation to re-pellet the DNA 3. DNA is re-suspended in distilled water or the buffer of choice, quantified and stored at -20°C. Purified DNA can subsequently be used in downstream applications which include, but are not limited to, PCR, array comparative genomic hybridization 4 (array CGH), methylated DNA Immunoprecipitation (MeDIP) and sequencing, allowing for an integrative analysis of tissue/tumor samples.

Protocol

1. Procedural notes

  • Xylene and phenol are toxic chemicals and should be handled in a fumehood. Refer to the material safety data sheet (MSDS) before use.
  • Xylene dissolves certain plastics; polypropylene tubes should be used as they tolerate these compounds.
  • Special tips may be purchased that contain an internal charcoal stopper. This prevents the xylene from dissolving any rubber components in the pipette. Alternatively, filter tips can be used.

2. Paraffin removal

  1. In a fumehood, add 800 μl of xylene (VWR, CABDH6216-4) to the labeled tube containing your specimen and place on a rocker with gentle shaking for 5 to 15 minutes to dissolve the paraffin.
  2. Pellet the sample by spinning at max speed (14,000 rpm or 16 000 x g) in a microcentrifuge for 3 minutes. Carefully withdraw the xylene supernatant and dispose in a polypropylene tube for discard in the xylene waste. Be careful not to disturb the pellet.
  3. Repeat xylene wash steps 1 and 2until paraffin is fully dissolved. This usually requires two to three washes, depending on the size of the tissue sample. A fully dissolved sample will appear soft, and will sometimes lose its structural integrity. The integrity of the sample can be gently assessed with a pipette tip.

3. Ethanol rehydration

  1. Add 800 μl of 100% ethanol (v/v) molecular biology grade ethanol, vortex, then spin for 3 minutes at 14,000 rpm in microcentrifuge. Remove the ethanol supernatant, being careful not to disturb the pellet.
  2. Add 800 μl of 70% ethanol (100% (v/v) ethanol diluted in distilled water (dH2O)), vortex, and spin for 3 minutes at 14,000 rpm. Carefully remove the ethanol supernatant.
  3. Add 800 μl of 50% ethanol (100% (v/v) ethanol diluted in distilled water (dH2O)), vortex, and spin for 5 minutes at 14,000 rpm. Carefully remove as much ethanol as possible by pipetting. Be extremely careful of disturbing the pellet at this point as fully rehydrated tissue will not pellet as well as dehydrated tissue.
  4. After removing the ethanol supernatant, air-dry the pellet for 5 minutes, being careful not to over dry.

4. Tissue digestion

  1. Add 200-500 μl of Lysis Buffer (formula below). Re-suspend the pellet using a pipette tip or a vortex. Extra effort at this point to fully re-suspend the tissue will result in a more complete digestion of the sample and a better yield of DNA.
  2. Incubate samples at 56°C in a water bath or heating block.
  3. For tissue cores, spike 20 μl of proteinase K (20 mg/ml stock solution, Invitrogen, AM2548 ) morning and evening.
  4. Repeat above digestion steps for 2 to 5 days until the tissue is fully dissolved.

Lysis Buffer

  • 10 mM Tris-HCl pH 8.0
  • 100 mM EDTA pH 8.0
  • 50 mM NaCl
  • 0.5% SDS
  • 200 μg/ml proteinase K (add just before use)

5. DNA clean up

  1. Add an equal volume of buffer saturated phenol (Fisher, BP1750I-400) and mix by inversion. Spin for at least 5 minutes at 14,000 rpm in microcentrifuge.
  2. Transfer the aqueous layer to a new tube. Note the interphase: is there a lot of white material?
  3. Repeat steps 1 and 2 on the aqueous fraction until the interphase is clear (typically 3 or more times). Perform back extractions* when the interphase is fuzzy to increase final yield.
  4. Once the interphase is clear, add an equal volume of phenol:chloroform:isoamyl alcohol (25:24:1) (Fisher, BP1752I-400) to the extracted aqueous fraction of your sample. Mix for 5 minutes and then spin for 5 minutes at 14,000 rpm. Thisreduces residual phenol and further sharpens the interphase, facilitating extraction of the aqueous layer
  5. Remove the aqueous layer to a new tube and treatwith RNase A at 100 μg/ml for 1 hour at 37°C.
  6. Repeat steps 1 to 4 to remove any remaining RNase A and collect the aqueous fraction. You should only need 1 or 2 buffer saturated phenol steps as there should be much less protein to remove than in the initial lysate.

*To perform back extractions add 50-100 μl of dH20 to the sample tube containing the interphase and organic portion. Invert the tube to mix, and spin the sample at 14,000 rpm in a microcentrifuge for 5 minutes. Collect the aqueous phase and add it to the previously acquired aqueous extraction. Continue back extractions until the interphase is clear.

6. DNA precipitation

  1. Estimate the volume of your collected aqueous layer.
  2. Add 1/10 the volume of 3 M sodium acetate pH 5.2 and 1 volume of 100% isopropanol (v/v) molecular biology grade (or 2.5 volumes of 100% ethanol).
  3. Mix well and put on ice or in a -20°C freezer for 30 minutes or overnight.
  4. Spin at maximum speed (14,000 rpm) at 4°C in microcentrifuge for 10 minutes
  5. Discard the supernatant.
  6. Wash the pellet with 70% ice cold ethanol to remove unwanted salts.
  7. Re-suspend the pellet in the buffer of choice (usually dH2O).

7. DNA quantification

  1. Quantify the concentration of DNA. The A260:A280 ratio should be ~1.8. For small quantities of DNA, measurement using a NanoDrop spectrophotometer is preferred.
  2. Following quantification, gel electrophoresis should be performed to test the quality of your sample DNA and determine whether contaminating RNA has been completely degraded .
  3. High quality extracted DNA is now suitable for downstream applications, or can be stored at -20°C for later use. If RNA is still present in your sample, repeat the DNA clean up and precipitation steps, and re quantify and qualify the quality of your samples.

Discussion

Biopsied or surgically excised tissues for histopathologic analysis and diagnosis are often formalin fixed and paraffin embedded (FFPE) for long term storage. With the growing interest in understanding the genetic basis of disease, the ability to extract DNA from these samples represents an invaluable source of diagnostic material that can be used for genomic analysis and translational studies. Historically FFPE samples were not considered a viable source for molecular analysis as nucleic acids may be heavily modified by protein-nucleic acid and protein-protein cross linking6. However, the discovery that protease digestion releases fragmented nucleic acids which are suitable for downstream analyses including PCR, array CGH, sequencing and methylation profiling, enables the use of these valuable specimens for genetic analysis 6.

DNA extraction from paraffin-embedded tissues is a robust procedure that relies on differential solubility to purify DNA. Extracted DNA quality and quantity and the success of subsequent DNA amplification is dependent on a number of parameters before, during and after extraction. These include, but are not limited to: type and amount of tissue, the type of fixative used for tissue preservation, the duration of fixation, age of the paraffin block and storage conditions, as well as the length of the desired DNA segment to be amplified 1,7. Removal of paraffin from the tissue is the most critical step for successful extraction as undissolved paraffin leads to poor sample quality and inhibition of PCR amplification.

Disclosures

The authors have nothing to disclose.

Acknowledgements

We would like to thank members of the Lam lab for their evaluation and critiques of this video and article. This work was supported by funds from the Canadian Institutes for Health Research.

Materials

Name Company Catalogue Number Comments
Xylene VWR CABDH6216- 4
1.7 ml SafeSeal Microcentrifuge Tubes Sorenson BioScience 11510
Spectrafuge 16M Microcentrifuge Labnet C0160-B
Lysis Buffer 10 mM Tris-HCl pH8,
100 mM EDTA pH 8,
50 mM NaCl,
0.5% SDS,
200 μg/ml Proteinase K
Proteinase K Stock Solution Invitrogen AM2548 20 mg/ml
Proteinase K Stock Solution      
Buffer Saturated Phenol pH 6.6/7.9 Fisher BP1750I-400
Phenol: chloroform: Isoamylalcohol (25:24:1, pH 6.7/8.0) Fisher BP1752I-400
RNase A Roche 10109169001 100mg
3M sodium Acetate pH 5.2 40.81g NaOAc in 80ml
Adjust to pH 5.2 with glacial acetic acid
Add dH2O to 100ml
Autoclave
ND 3300 Spectrophotometer NanoDrop

References

  1. Santos, M. C., Saito, C. P., Line, S. R. Extraction of genomic DNA from paraffin-embedded tissue sections of human fetuses fixed and stored in formalin for long periods. Pathol Res Pract. 204, 633-636 (2008).
  2. Hilz, H., Wiegers, U., Adamietz, P. Stimulation of proteinase K action by denaturing agents: application to the isolation of nucleic acids and the degradation of ‘masked’ proteins. Eur J Biochem. 56, 103-108 (1975).
  3. Sambrook, J. o. s. e. p. h., R, D. . Molecular Cloning: A Laboratory Manual. , (2001).
  4. Kennett, J. Y., Watson, S. K., Saprunoff, H., Heryet, C., Lam, W. L. Technical demonstration of whole genome array comparative genomic hybridization. J Vis Exp. , (2008).
  5. Thu, K. L. Methylated DNA immunoprecipitation. J Vis Exp. , (2009).
  6. Tang, W. DNA extraction from formalin-fixed, paraffin-embedded tissue. Cold Spring Harb Protoc. , (2009).
  7. Hongxin Fan, M. L. G., G, M. L. DNA Extraction from Paraffin-Embedded Tissues. Molecular Pathology Protocols. 49, 1-4 (2001).

Play Video

Cite This Article
Pikor, L. A., Enfield, K. S. S., Cameron, H., Lam, W. L. DNA Extraction from Paraffin Embedded Material for Genetic and Epigenetic Analyses. J. Vis. Exp. (49), e2763, doi:10.3791/2763 (2011).

View Video