Superior Lacrimal Gland Removal: A Surgical Technique to Remove the Palpebral and Orbital Parts of Superior Lacrimal Gland from Rabbit Model

Published: April 30, 2023

Abstract

Source: Honkanen, R. A. et al., Establishment of a Severe Dry Eye Model Using Complete Dacryoadenectomy in Rabbits. J. Vis. Exp. (2020).

This video describes the surgical procedure to remove the two parts: palpebral and orbital of the superior lacrimal gland from a rabbit to create a dry eye disease model. This rabbit model is suitable for studies of ocular surface homeostasis, pathophysiology and ocular therapeutics.

Protocol

All procedures involving animal models have been reviewed by the local institutional animal care committee and the JoVE veterinary review board.

Use New Zealand White (NZW) rabbits weighing 2−3 kg Lightly sedate animals placed in a restraining bag with subcutaneous acepromazine as above (1 mg/kg). Remove all fur on the face and dorsal surface of the skull to visualize the surgical landmarks. Trim fur with cutting shears leaving residual fine fur about 1 mm in length. Remove all residual fur using mild depilatory cream following the manufacturer's instructions.

1. Removal of OSLG

  1. Infiltrate the incision sites (surgical marking pen lines and upper posterior lid) with a 50:50 mixture of 2% lidocaine with 1:100,000 epinephrine and 0.5% bupivacaine using a 5 cc syringe with a 30 G needle (Figure 1A).
    NOTE: Syringe and needle size are not critical.
  2. Use a Colorado needle connected to an electrosurgical unit to make the skin incisions along the surgical markings. Settings can vary based on clinical response and typically are between 10 to 15 units for both cut and coagulation (Figure 1B).
  3. Apply opposing tension across the skin incision to separate the tissues and expose the underlying frontoscutularis muscle fibers.
  4. Apply medial pressure on the globe to aid visualization of the OSLG, seen as bulging tissue located just medial or deep to the frontoscutularis muscle fibers. If necessary, move these muscle fibers to the side in order to expose the underlying incisure.
  5. With toothed forceps (0.3) and capsulotomy scissors, gently retract and cut the fibrous capsule overlying the OSLG. The OSLG typically has a pale tan color (Figure 1C).
  6. Using toothed or non-toothed forceps, grasp the OSLG gland tissue and gently pull it out through the superior incisure using a "hand over hand" technique. Cut small, fibrous bands using capsulotomy scissors to free the gland from its position in the orbit (Figure 1D).
    NOTE: As the OSLG gland tissue is removed, it will begin to coalesce into a large tube-like structure (main excretory duct).
  7. When the gland has been removed as completely as possible, use generous cautery with the Colorado needle to create tissue char, truncating the gland within the incisure as deeply as possible. This will later serve as a confirmatory landmark during removal of the PSLG.

2. Removal of PSLG.

  1. Evert the upper eyelid using a cotton-tipped applicator. The bulbous end of the PSLG is usually easily visible.
    NOTE: In some anatomic dissections, it may be possible to visualize the main excretory duct as a pale linear structure about 1 or 2 mm wide.
  2. Engage the PSLG with toothed forceps (0.3) and retract it from the eyelid surface while using capsulotomy scissors to cut around its base separating it from the underlying tarsus (Figure 2A).
  3. Control moderate bleeding with the monopolar cautery.
  4. Apply continuous traction on the separated tissue to maintain a tissue plane for dissection. This will allow the main excretory duct of the SLG to be removed as well (Figure 2B).
    NOTE: As the dissection is carried out, it will typically advance to the superior orbital rim where it is possible to see the cautery marks left behind from removal of the more superior and medially located OSLG.

Representative Results

Figure 1
Figure 1: Removal of the OSLG. (A) Surgical sites are infiltrated with anesthetic using a 50:50 combination of 2% lidocaine with 1:100,000 epinephrine and 0.5% bupivacaine, which is injected into the upper lid and along the incision lines to minimize discomfort during the procedure. (B) A Colorado microdissection needle is used to incise the skin and superficial muscle layers along the pre-marked surgical incision sites. Gentle traction across the wound is applied to help create the dissection plane. The small pinpoint burns (arrow) were made with the Colorado needle at equidistant points along the incision line to help optimally realign the tissues during wound closure. (C) The OSLG is exposed after tissues overlying the posterior incisure have been mobilized (arrow). The capsule of the gland has been incised. The OSLG can be prolapsed by applying medial pressure to the globe facilitating its removal. (D) Forceps are used to engage the OSLG and gently remove it from its deeper position within the orbit through the posterior incisure.

Figure 2
Figure 2: Removal of the palpebral superior lacrimal gland (PSLG) and excretory duct. (A) Following eversion of the upper eyelid, the bulbous portion of the PSLG is engaged with forceps and dissected off the tarsus using scissors. Traction applied to the PSLG with forceps is critical to maintaining the surgical plane. (B) The dissection of the PSLG and the main lacrimal duct is carried superiorly toward the orbital rim using sharp dissection and continuous traction on the gland and duct tissues to maintain the appropriate surgical plane. The dissection should proceed to the point where the OSLG was removed.

Divulgations

The authors have nothing to disclose.

Materials

acepromazine,  Aceproinj  Henry Schein Animal Health, Dublin, OH  NDC11695-0079-8 0.1ml/kg subcutaneously injection for rabbit sedation
animal restraining bag   Henry Schein Animal Health, Dublin, OH  Jorvet J0170 Use appropriately sized bag.
bupivacaine, 0.5%   Hospira Inc, Lake Forest IL NDC: 0409-1162-02  Mixed 50:50 with 2% lidocaine with 1:100,000 epinephrine for infiltration of incision sites.
Colorado needle    Stryker Craniomaxillofacial, Kalamazoo, MI N103A Use with electrosurgical unit to make incisions
electrosurgical unit with monopolar cautery plate    Valleylab, Boulder, CO Force FXc Use with electrosurgical unit to make incisions
forceps, Bishop Harmon  Bausch and Lomb (Storz), Bridgewater NJ E1500-C Use toothed forceps for dacryoadenectomy
needle, 30-gauge  BD, Franklin Lakes, NJ   REF 305106 For infiltration of incision sites; syringe and needle size are not critical
rabbit, New Zealand White   Charles River Labs, Waltham, MA (NZW) 2-3 kg  Research animals
scissors, Vannas McKesson   Medical-Surgical, San Francisco, CA  Miltex 2-130 Capsulotomy scissors for dacryoadenectomy
syringe, 5 cc   BD, Franklin Lakes, NJ REF 309603  For infiltration of incision sites; syringe and needle size are not critical

Tags

Play Video

Citer Cet Article
Superior Lacrimal Gland Removal: A Surgical Technique to Remove the Palpebral and Orbital Parts of Superior Lacrimal Gland from Rabbit Model. J. Vis. Exp. (Pending Publication), e20846, doi: (2023).

View Video