/
/
Micromechanical Tension Testing of Additively Manufactured 17-4 PH Stainless Steel Specimens
This content is Free Access.
Capítulos
- 00:04Introduction
- 01:02Sample Preparation for Photolithography
- 01:41Performing the Photo-Resist Patterning
- 02:40Wet-etching and FIB Milling
- 03:34Micro-Tensile Test
- 04:12Results: Analysis of the Prepared Steel Surface
- 04:56Conclusion
Presented here is a procedure for measuring fundamental material properties through micromechanical tension testing. Described are the methods for micro-tensile specimen fabrication (allowing rapid micro-specimen fabrication from bulk material volumes by combining photolithography, chemical etching, and focused ion beam milling), indenter tip modification, and micromechanical tension testing (including an example).
