Detrusor Smooth Muscle Cell Isolation: An Enzymatic Digestion Procedure to Obtain DSM Cells from Human Urinary Bladder Specimens

All procedures involving human participants have been performed in compliance with the institutional, national, and international guidelines for human welfare and have been reviewed by the local institutional review board.

1. Dissection of DSM Tissues and Preparation of Mucosa-free DSM Pieces

1. Examine the whole thickness urinary bladder specimen that arrived in the lab from the operating room in a tightly sealed container filled with the cold dissection/digestion solution (Figure 1 and Table 1 for composition of DS).
   NOTE: The specimen is usually kept in cold DS from a few hours to overnight prior to arrival in the laboratory. For longer storage, DS (Table 1) is supplemented with 1 mM CaCl₂.
2. Remove and rinse the human whole thickness DSM specimen (containing all layers including mucosa, DSM, and serosa) with ice-cold DS to wash out attached debris and blood.
3. Pin the urinary bladder specimen, mucosa facing upward and serosa down, onto a silicone enantiomer-coated (Table of Materials) 150 mm diameter round dish filled with ice-cold DS (Figure 1B).
4. Remove the adjacent adipose tissue, blood vessels, epithelium (urothelium) and muscularis mucosa from the specimen by sharp dissection using microscissors and forceps.
5. Cut out several mucosa-free DSM pieces (~2–3 mm long and 4–6 mm wide) (Figure 1C).

2. Enzymatic Dissociation of DSM Pieces Yielding Freshly Isolated Single DSM Cells

1. Place 3 to 6 DSM pieces into a tube containing 1 to 2 mL of pre-warmed (~37 °C) DS containing papain and dithiothreitol (DS-P, Table 1) and incubate DSM pieces in DS-P for 30–45 min at ~37 °C gently shaking the tube occasionally (once every 10–15 min).
   NOTE: To optimally control the temperature for enzymatic treatment, tubes with tissue pieces and enzyme solutions are placed in either a glass tissue chamber filled with water connected to a circulating heated water bath (Figure 1D) or a high-precision temperature-controlled shaking water bath (Figure 1E).
2. Remove DS-P from the tube, briefly wash DSM pieces with ice-cold DS, discard cold DS from the tube leaving DSM pieces sitting at the bottom of the tube.
3. Add 1 to 2 mL of DS-containing collagenase type II (DS-C, Table 1) to the tube with DSM pieces; gently mix and incubate for 25–40 min at ~37 °C gently shaking the tube occasionally (every 10–15 min).
4. Discard DS-C and wash enzyme-treated DSM pieces 5–10 times with ice-cold DS.
5. Following the last wash, leave DS solution inside the tube; gently triturate with a fire-polished Pasteur pipette several times to release single DSM cells.
6. Place a few drops of DS solution containing dispersed DSM cells onto a glass-bottom chamber or a coverslip and visually inspect for the quality under a microscope (using a 20x or 40x objective) after at least 5 min following the application to allow the cells to adhere to the bottom.
7. Immediately use freshly isolated DSM cells for electrophysiological experiments or store the cells in a tube containing DS at ~4 °C either on ice or in a refrigerator until use (typically for up to 8 h of preparation).
   NOTE: Within the same preparation the quality of cells varies from highly viable to over-digested, dead DSM cells (Figure 2). When the sequential papain-collagenase method yields a very high number of unviable cells, the preparation is discarded, and a new digestion of DSM pieces is carried out but with reduced incubation intervals. If the procedure results in too few DSM cells, then for the subsequent digestion of DSM pieces, the incubation intervals are increased. Positive immunoreactivity to α-smooth muscle actin confirms the identity of DSM cells (Figure 3).

Table 1: Compositions of dissection/digestion solution (DS), and pipette and extracellular solutions used in perforated patch-clamp experiments.